VRRP配置命令（国外英文资料）.doc

VRRP配置命令（国外英文资料） The 1.1 VRRP configuration command 1.1.1 was debugging VRRP Command Debugging VRRP {state | packet} Undo debugging VRRP {state | packet} The view User view Parameters State: the status debug switch for VRRP; Packet: VRRP message debugging switch; 【 description 】 The debugging VRRP command is used to turn on the VRRP debug switch, and the undo debugging VRRP command is used to turn off the VRRP debug switch. By default, the switch turns off the VRRP debug switch. [for example] # open the VRRP state debug switch. The Quidway was debugging VRRP state Vlan-interface1 | Virtual Router 1: INITIALIZE - MASTER Table 1-1 display VRRP displays the domain specification table content Content description Vlan - Interface1 Virtual router interface Virtual Router1 Virtual router VRID The INITIALIZE The original state The MASTER A new state 1.1.2 display VRRP Command Display VRRP [{interface | statistics} vlan-interface interinterface - num] [virtual - router - ID] The view All views Parameters Vlan-interface interface - num: interface name. Virtual - router - ID: VRRP backup group number, the backup group number ranges from 1 to 255. 【 description 】 The display VRRP command displays the status information of the VRRP. If you do not enter the interface name and the backup group number, the system will display the status information of all the backup groups on the switch. If only the specific interface name is entered, the status information for all the backup groups on that interface is displayed; If the interface name and the backup group number are entered, the status information of the backup group is displayed on that interface. [for example] # displays the backup group information on the interface on the switch. [quidway-vlan-interface1] display VRRP Run Method: VIRTUAL - MAC VIRTUAL Ip Ping: Disable Interface: vlan-interface1 VRID: 1 adver.timer: 1 Admin Status: UP State: Initialize Config Pri: 100 Run Pri: 90 Preempt Mode: YES Delay Time: 0 Auth Type: NON