朗读30226朗读0226.doc

②一般工业固体废弃物 (2) general industrial solid waste 包括：废塑料包装袋、废工程土、废实验材料、废炉渣。 Include: plastic bags, waste, waste engineering soil experiment materials, the waste slag. ③危险废物包括：废电池、废硒鼓、废墨盒、色带、荧光灯管、医疗废物、废化学品包装物等。 (including hazardous waste, waste batteries, waste drum unit, ink cartridges scrap, ribbon, fluorescent tubes, medical waste, waste chemicals, packing materials, etc. ④生活垃圾：包括办公室垃圾、浴室垃圾、盥洗室垃圾、食堂生活垃圾等。 (4) waste: including the, bathroom, bathroom garbage landfill office, dining room, living garbage. ⑤医疗固废：注射器、输液器等一次性医疗垃圾和外伤医用敷料。 (5) medical solid waste: syringes, infusion sets and so on the disposable medical waste and trauma medical dressings. 项目经理部应根据以上的分类方法和本工程的实际情况，将废弃物分类存放在指定地点，并应设置明显的标识。 Project joint should be based on the above classification method and the actual situation of the project, will be stored in a designated place for waste classification, and should set up the clear identification. （3）固废的搬运 (3) of the solid waste handling 现场指定专人将其生产的固废送到固废统一存放场所，标识分类存放。 Site appoint someone to the production of solid waste to the solid waste storage sites, classified depositing. 在搬运过程中要注意，严防固废的撒漏、挥发、倾倒，杜绝二次污染发生。 To pay attention to in the process of handling, beware of leakage and volatilization, dumping of solid waste, prevent secondary pollution. （4）固废的存放 (4) the storage of solid waste 相关责任部门要指定固废统一存放场所，并由专人管理。 Responsible department to specify solid waste storage sites, and the personnel management. 存放场所要分类存放各种固废，并有明显标识 Storage place to store all kinds of solid waste classification, and there is a clear identity 存放场所要做好渗漏处理，要做到防雨淋、防流失、防恶臭，保持周围环境清洁。 Storage place to disposal of the leakage, to prevent rain, prevent erosion, against the stench, keep the environment clean. （5）固废的处置和回收 (5) of the solid waste disposal and recycling 对确有利用价值的固废应进行综合利用或者对外销售，减少资源的浪费。 Is found to have use value of comprehensive utilization of solid waste should be done or foreign sales, reduce the waste of resources. 危险固废必须由有资质的单位进行处理，并根据《相关方管理规定》要求处置单位在运输和处置过程中严格执行国家标