带式输送机安装说明书.doc

带式输送机 Blet conveyor 安装使用说明书 Installation and operation instruction 青岛永昌泰机械设备有限公司 一、 带式输送机安装说明书 Belt conveyor installation instruction 1. 带式输送机安装标高,均以图纸为准。 Belt conveyor installation length are with drawings 2. 在设备安装中如发现套用图纸或土建图纸所注标高与工艺布置图不一致时需核对其标高。 It is necessary to check its standard height when that of drawings or buiders work drawing are not the same with Process arrangement in process of installation. 3. 带式输送机安装、调整、试运行等内容除按本说明书要求进行外、设备安装手图及厂家图纸说明书和技术要求《带式输送机施工及验收技术规范》进行 施工和验收。对主要设备应建立施工、验收记录。 Belt conveyor in installation, adjustment, commissioning, etc according to the content in addition to the specifications, equipment installation hand diagram and drawings specifications and technical requirements of the manufacturer of the belt conveyor technology standard construction and acceptance of construction and acceptance. For major equipment shall establish construction and acceptance record. 4. 带式输送机安装前,应对土建施工的建筑物的各层标高、基础、埋件及预留孔洞等进行全面检查,确认符合有关的质量验收标准后方可进行安装。 It had better check completely standard height、foundation、built-in and reserve holes of every floor of the building befor installation of belt conveyor, and installation is feasible after confirming that comply with the relevant quality acceptance standard . 5. 所有零部件(包括外协件)必须经检验合格,配套件、外购件等必须有合格证书方可进行安装。 All components (including outsourcing) must be passed the inspection, fittings, purchased components must be qualified certificate for installation. 二、 带式输送机安装的技术要求及验收的质量标准. Belt conveyor installation technology requirements and acceptance standards of quality. 1. 驱动装置Actuating device 1.1 传动滚筒中心线与减速器输出轴中心线同轴度误差应不大于Ф0.1mm. Error from transmission roller center line and reducer output shaft centerline the coaxial tolerance should not be more than 0.1 mm. 1.2 减速器输入轴中心线与电动机轴中心线同轴度误差应不大于Ф0.1mm. Error from reducer input shaft centerline and motor shaft centerline the coaxial tolerance should not be more than 0.1 mm. 1.3 联轴器两半体安装时,其端面跳动及径向跳动的允许误差应不大于下表所列数值. when installing Coupling