带式输送机安装(3).docx

带式输送机 Blet conveyor 安装使用说明书 Installation and operation instruction 联系电话：0738-3537338 传真：0738-3537909湖南省映鸿科技有限公司 20009年 Tel :0738—3537338 fax:073L 3537909 YingHong Science TechnologyCo.Ltd. Xinhua,Hunan2009 一、带式输送机安装说明书 Belt conv eyor in stallatio n in structi on 带式输送机安装标高，均以图纸为准。 Belt conveyor installation length are with drawings 在设备安装中如发现套用图纸或土建图纸所注标高与工艺布置图不一致 时需核对其标高。 It is necessary to check its standard height when that of drawings or buiders work draw ing are not the same with Process arra ngeme nt in process of in stallati on. 带式输送机安装、调整、试运行等内容除按本说明书要求进行外、设备 安装手图及厂家图纸说明书和技术要求《带式输送机施工及验收技术规范》进 行 施工和验收。对主要设备应建立施工、验收记录。 Belt conv eyor in in stallati on, adjustme nt, commissio ning, etc accord ing to the content in additi on to the specificati ons, equipme nt in stallati on hand diagram and draw ings specificati ons and tech ni cal requireme nts of the manu facturer of the belt conv eyor tech no logy sta ndard con structi on and accepta nee of con structi on and accepta nee. For major equipme nt shall establish con structi on and accepta nee record. 带式输送机安装前，应对土建施工的建筑物的各层标高、基础、埋件及 预留孔洞等进行全面检查，确认符合有关的质量验收标准后方可进行安装。 It had better check completely standard height 、 foundation 、 built-in and reserveholesof every floor of the build ing befor in stallati onof belt conv eyor, and in stallatio n is feasible after con firm ing that comply with the releva nt quality accepta nee sta ndard . 所有零部件(包括外协件)必须经检验合格，配套件、外购件等必须有合 格证书方可进行安装。 All comp onents (in clud ing outsourc ing) must be passed the in specti on, fittings, purchased components must be qualified certificate forin stallati on. 二、带式输送机安装的技术要求及验收的质量标准 Belt conv eyor in stallati on tech no logy requireme nts and accepta nee sta ndards of quality. 驱动装置 Actuating device 1.1传动滚筒中心线与减速器输岀轴中心线同轴度误差应不大于 ①0.1mm. Error from tran smissi on roller cen ter line and reducer output shaft cen terl ine the coaxial tolera nee should not be more tha n 0.1 mm. 1.2减速器输入轴中心线与电动机轴中心线同轴度误差应不大于 ①0.1mm. Errorfrom reducer in put shaft cen