【2017年整理】PMI设备维护.ppt

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * Replacement of Ethernet switch power supply 替换Ethernet 交换机电源 Disconnect the power cable of the power supply unit on BL1: (look at the cable number) 断开BL1上的电源电缆（注意电缆编号） Disconnect the cables on the power supply unit 断开供电单元上的电缆 Remove the power supply unit: press on the tab Tab Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Replacement of SCOM PC 替换SCOM PC Turn off the PC 关闭PC Remove the cables on the rear face of the PC 去除PC后面板上的电缆 Remove the dongle 去除dongle Unscrew the 4 PC attachment screws 拆除4个PC 螺钉 Remove the PC 去除PC Put the new SCOM PC (A or B) 放入新的SCOM PC（A 或B） Screw the attachment screws 安装螺钉 Reconnect the cables 重新连接电缆 Put the dongle in position 将dongle 放到位置 Install the SCOM software 安装SCOM 软件 Parameterize the IP_config file 配置IP_config 文件中的参数 Configure IP addresses of the PC 配置PC 中的IP 地址 Reboot the PC 重新启动PC Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Replacement of SAM PC 替换SAM PC Turn off the PC 关闭PC Remove the cables on the rear face of the PC 去除PC后面的电缆 Remove the dongle 去除dongle Unscrew the 4 PC attachment screws 拆除4个螺钉 Remove the PC 移走PC Put the new SCOM PC (A or B) 放入新的SCOM PC（A 或B） Screw the attachment screw 装入螺钉 Reconnect the cables 重新连接电缆 Put the dongle in position 将dongle就位 Install the MEI logger 安装MEI logger Install the prodongle software 安装prodongle软件 Reboot the PC 重新启动PC Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Hexadecimal coding reminder十六进制编码 Hexadecimal coding 16进制编码: Coding in base 16: from 0 to F 基于16进行编码：从0至F Code Decimal 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Hexadecimal 0 1 2 3 4 5 6 7 8 9 A B C D E F binary 0 1 10 11 100 101 110 111 1000 10