真空包装机控制器说明.DOC

PNC-01 OPERATION MANUAL Version：2007/06/28  Basic Operation Instructions Standby Mode： After turning on the power of machine, at this time the operation panel is under standby mode, STB lamplights up, other lamps all turn off, digital indicator is off, too. Start Operation Panel： After pressing POWER ON, the digital indicator shows software revision, then about 3 seconds later, enters into general operation mode, during this time the digital indicator shows the numeric values of program and VAC steps used last time, STB and VAC lamps light up. Start Vacuum Packaging： During this time, put package in the chamber, close the vacuum lid, then start proceeding vacuum packaging mode. Machine will accord to the steps of VAC、GAS、SEAL1、SEAL2、COOL、SOFT and so on to proceed packaging step by step. When finishing, cause will recover to normal air pressure, so the vacuum lid will open automatically. Setting Parameters： Under general operation mode, press either one of buttons over 3 seconds, at this time, figure、VAC lamps flash, enters into setting mode, then press the buttons to select the items which required to be set, change numeric value with + - buttons, press either one of Program buttons, can store file and escape this mode. Close Operation Panel：Under general operation mode, press POWER OFF button, can turn off the operation panel, then only STB lamp will light up. Packaging Flow The Adjustable Items List Close Vacuum Lid (CLOSE) Vacuum (VAC steps) Gas Flushing (GAS steps) Sealing 1 Heat (SEAL1 step) Sealing 2 Heat (SEAL2 steps) Sealing Bar Cool (COOL steps) Slow Speed Pressure Back (SOFT steps) Open Vacuum Lid (OPEN) Steps With vacuum percent、vacuum percent extension seconds、and use only time counted with seconds to control vacuum. Flushing gas, with seconds to control. According to the set seconds to heat sealing bars 1 2 individually at the same time, stop heating separately, after all stop, enters next step. The cooling tim