文档详情

负载型杂多酸盐催化合成乙酸正丁酯.pdf

发布:2017-07-18约7.14千字共3页下载文档
文本预览下载声明
第 29卷第3期 化学工业与工程技术 Vo1.29 NO.3 2008年 6月 Journal of Chemical IndustryEngineering Jun.,2008 负载型杂多酸盐催化合成乙酸正丁酯 单秋杰 (齐齐哈尔大学 化学与化学工程学院,黑龙江 齐齐哈尔 161006) 摘要:用SiO 为载体,在4种不同温度下分别负载硅钨杂多酸和磷钨杂多酸,以正丁醇和冰乙酸为 原料,催化合成乙酸正丁酯。探讨了醇酸物质的量比、催化剂的用量、反应时间和反应温度对酯化率的 影响。结果表明,反应最佳条件为:醇酸物质的量比1:1,催化剂用量为原料量的 1 ,反应温度 120 ℃,反应时间5 h;在180℃下SiO 负载的SiW 催化效果最好,催化剂在重复使用 3次的情况下活性无 明显下降。 关键词:负载杂多酸;催化合成;乙酸正丁酯 中图分类号:O621 文献标识码:A 文章编号:1006—7906(2008)03—0038—03 Synthesis of n-butyl acetate by solid heterOpOlyacids catalyst Shan Qi ie (School of Chemistry and Chemical Engineering,Qiqihar University,Qiqihar 161006,China) Abstract:The eight kinds of heteropolyacids are supported by SiO2 at four kinds of temperature,then the 一butyl acetate is synthesized catalystically from butanol and glacial acetic acid.The influences of molar ratio of butanol to glacial acetic acid,dos— age of catalyst,reaction time and reaction temperature on the esterification ratio are discussed.The results indicate that the best reaction conditions are that molar ratio butanol to acetic acid is 1:1,the dosage of catalyst is 1 of the materials gross, the reaction temperature is 120℃,and the reaction time is 5 h.The effect of the SiW12/sio2 catalyst which is supported by SiO2 at 1 80℃ is the best.The catalytic activity has no o ious descent after reused three times. Key words:Solid heteropolyacids;Catalyze synthesis;n—Butyl acetate 乙酸正丁酯是重要的有机溶剂,目前,我国一般 1.2 负载型杂多酸盐催化剂的制备 采用硫酸催化法生产,污染环境,设备腐蚀严重。由 以SiO。为载体,采用浸渍法制备D]。用分析天 于环保法规对环境和安全问题不断提高要求,国内 平称取2 g的H [SiW。2O 。]和2 g的H [Pw 2O 。], 外都在探索酯化反应的最佳催化剂[1]。目前,有关 分别配成饱和溶液于烧杯中,再用分析天平分别称 杂多酸催化酯化的研究大多限于均相催化体系,由
显示全部
相似文档