客户关系管理系统操作手册.doc.doc

中经科环客户关系管理系统 操作手册 目录 1. 目录 1 1.1. 使用者应具备知识 1 2. 怎么登陆系统 2 3. 首页 2 3.1. 我的办公室 2 3.1.1. 修改密码 2 3.1.2. 日程管理 3 3.2. 客户管理 6 3.2.1. 客户拜访 6 3.2.2. 客户池 14 3.2.3. 联系客户计划 17 3.2.4. 联系人 18 3.2.5. 联系记录 19 3.2.6. 公共检索 20 3.2.7. 客户管理策略 21 3.3. 数据导入 22 3.3.1. 导入客户 22 3.3.2. 导入联系人 25 3.4. 系统配置 29 3.4.1. 定义业务字典 29 3.4.2. 数据备份 30 3.4.3. 数据还原 31 使用者应具备知识 用户需对计算机的的上网操作比较熟悉；对web浏览器（如Internet Explorer）的使用有一定了解。 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the thickness. Once the lif