APC NetBotz Accessories Sensors Pod Mounting Bracket Kit (Sheet)说明书用户手册(1).pdf

NetBotz Pod Mounting Kit Thank you for purchasing this NetBotz Pod Mounting Kit. Using the parts included with this kit, you can mount one NetBotz Pod (such as the Camera Pod 120 or Sensor Pod 120) in a variety of locations, including: • In a server cabinet or Telco rack • From a drop ceiling • Wall-mounted Packing List This package includes the following parts (illustrations are not to scale): • NetBotz Pod rack-mount bracket with swivel mount • Drop-ceiling scissor clip mount • Round wall-mount bracket with rubber cover • Two 2” extension bars (can be used to extend the distance of the pod from any of the mounting brackets) • Set screw and Allen wrench (can be used to replace the thumb-screw assembly on the swivel mount, thereby discouraging tampering with the orientation of the pod once it has been mounted) Using the Rack-Mount Bracket To mount a NetBotz pod in a server cabinet or Telco rack using the rack-mount bracket: 1. Choose the location and position in which the rack-mount bracket will be installed. 2. Mount the rack-mount bracket. The mounting holes are located at the end of the bracket, and will position the pod parallel to the front of the rack or cabinet. Depending on which way you have the bracket facing, the pod will be positioned approximately 2” NetBotz Pod Mounting Kit in front of or 2” behind the surface on which the bracket is mounted. 3. Connect the pod to the swivel mount on the end of the rack-mount bracket. To adjust the position of the pod once mounted, loosen the thumbscrew on the swivel mount and adjust the position of the pod. When finished, tighten the thumbscrew to lock the pod in place. 4. Connect the pod to your NetBotz appliance or to a USB hub that is connecte