消防灭火系统的施工方案（二）.doc

消防灭火系统的施工方案（二） 消防灭火系统的施工方案（二）提要：应根据图纸设计规范和技术交底内容对管道进行外观检查，是否有裂纹、砂眼等。抽查阀门，做强度、严密性试验。核对喷头 更多 消防灭火系统的施工方案（二） 流程：预制-安装-试压-调试 安装： 消火栓系统安装： a）应根据图纸设计规范和技术交底内容对管道进行外观检查，是否有裂纹、砂眼等。抽查阀门，做强度、严密性试验。核对消火栓箱、阀门的型号规格是否符合设计要求，有无合格证。 b）为防止消火栓阀关闭不严，且不易打开，因此在安装前必须对阀门严格检查，开闭不灵活者禁止使用。 c）消火栓要严格按规范规定安装，室内消火栓，栓口朝外，阀门中心距地面为，阀门距箱侧面为140mm，距箱后表面为100mm。 d）水龙带应根据箱内构造将水龙带挂在箱内的挂钉或水龙带盘上。 试压: 建立一个临时上、下水系统，每层甩头由阀门控制，在每个管路最高处设排气口，最低点设泄水口。试验压力为工作压力加，最低不小于。系统灌满水后，30min压力降不超过，降至工作压力，外观检查无渗漏为合格。自动喷水系统在这次试压的基础上，安装喷头、水流指示器，再进行一次试压，压力为，应对管子特别是丝扣部位仔细检查，如发现问题应及时整改。对有吊顶的消防喷淋管道严格保护第一次试压管道，顶棚做完后即进行第二次试压。 防腐： 消防管道明装部分外刷银粉二道。 (E）冲洗： 室内消火栓系统在交付使用前和自动喷水灭火系统安装喷头前，应将室内管道冲洗干净，其冲洗水量应达到消防最大设计流量。冲洗时应将冲洗水排入雨水或排水管道。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation