华为配置命令（HUAWEI configuration command）.doc

华为配置命令（HUAWEI configuration command） Basic command EN enters privileged mode Conf enters global configuration mode In S0 enters serial 0 port configuration IP, add, xxx.xxx.xxx.xxx, xxx.xxx.xxx.xxx, add IP address and mask, telecom allocation Enca hdlc/ppp bundled link protocol HDLC or PPP IP unn E0 Exit back to global configuration mode In E0 enters the Ethernet interface configuration IP, add, xxx.xxx.xxx.xxx, xxx.xxx.xxx.xxx, add IP address and mask, telecom allocation Exit back to global configuration mode IP route 0.0.0.0 0.0.0.0 S 0 adds routing table ENA passWord password Write Exit Most of the above are applied according to China Telecom DDN line Common user mode Enable to privileged user mode Exit quit configuration Help system help Brief Language language mode switching Ping checks for network host connections and whether the host is reachable Show display system operation information Telnet remote login function Tracert tracks which routers go to the destination Clear clears all statistical information Clock management system clock Configure enters global configuration mode Debug turn on debug switch Disable returns normal user mode Download downloads new versions of software and configuration files Erase erase configuration in FLASH Exec-timeout opens the EXEC timeout exit switch Exit quit configuration First-config sets or clears the initial configuration flag Help system help Brief Language language mode switching Monitor opens the user screen debug information output switch No turn off the debug switch Ping checks for network host connections and whether the host is reachable Reboot router restart Setup configures router parameters Show display system operation information Telnet remote login function Tracert tracks which routers go to the destination Unmonitor closes the user screen debug information output switch Write saves the current configuration parameter to FLASH MEM Display current-configuration displays the current configuration information