12-Volt Negative Ground Installation Instructions（12伏-地面安装说明）.pdf

12-Volt Negative Ground Installation Instructions For Part Number: 1141, 1164, 1165, 1181 CAUTION!!! Before installing, please read the following important informationCAUTION!!! Before installing, please read the following important information 1. The Ignitor is designed for 12-Volt negative ground systems. 2. Leaving the ignition “ON” with the engine “OFF” for an extended period could result in permanent damage to the Ignitor. 3. See Chart on back page for coil recommendations. 4. Four and six cylinder engines require a minimum of 3.0 ohms of primary resistance and eight cylinder engines require a minimum of 1.5 ohms of primary resistance. Do not remove resistors if the coil primary resistance is less than specified. 5. If your Ignition coil has the recommended primary resistance, remove or bypass all external resistors. 6. The Ignitor is compatible as a trigger for most electronic boxes. DISASSEMBLY 1. PRIOR TO INSTALLATION TURN IGNITION SWITCH OFF OR DISCONNECT THE BATTERY 2. Disconnect point wire from negative (-) coil terminal. 3. Remove distributor cap. Do not disconnect spark plug wires from cap. Examine cap for wear or damage. Replace as needed. 4. REMOVE DISTRIBUTOR FROM ENGINE. Note position of rotor before removing distributor. 5. Remove rotor. Examine rotor for wear or damage. Replace as needed. 6. Remove point wire from distributor point assembly. Remove points wire from distributor. 7. Remove breaker point assembly and condenser. Retain screws and washers to install Ignitor module. 8. Remove point wire from negative (-) terminal of the coil. 9. The Ignitor does not require any modification to the distributor. Therefore the points, condenser and hardware can be used as backup. 10. Clean all dirt and excess oil from the breaker p