气焊工操作施工安全交底.doc

气焊工操作施工安全交底 气焊工操作施工安全交底提要：乙炔气瓶必须装减压阀和防回装置，乙炔气瓶与氧气瓶之间距离不得小于5m，严禁平放、曝晒 气焊工操作施工安全交底 1、气焊工须持特种作业证上岗，作业证过期未年审的不准施焊作业。施焊作业必须办理动火审批手续。 2、施焊场地周围应清除易燃易爆物品或进行覆盖、隔离，并在施焊部位配备灭器材。 3、每台电焊机应有专用电源控制开关。开关的保险丝容量，应为该机的1．5倍，严禁用其它金属丝代替保险丝，完工后，切断电源。 4、必须在易爆易爆气体或液体扩散区施焊时，应经有关部门检试许可后方可施焊。 5、乙炔气瓶必须装减压阀和防回装置，乙炔气瓶与氧气瓶之间距离不得小于5m，严禁平放、曝晒、距易燃易爆物品和明火的距离不得小于10m。检验是否漏气，要用肥皂水，禁用明火。氧气瓶、氧气表及焊割工具上，严禁沾染油脂。 6、气瓶的购运，储存和领用必须严格执行公安部门的有关规定。经常检查氧气瓶与磅表头处的螺绞是否滑牙，橡皮管是否漏气，焊枪嘴和枪身有无阻塞现象。 7、点火时，焊枪口不准对人，正在燃烧的焊枪不得放在工件或地面上，带有乙炔和氧气时，不准放在金属器内，以防气体逸出发生燃烧事故。严禁在带压力的容器或管道上施焊，焊接带电的设备必须先切断电源。 8、作业结束，应将气瓶气阀关好，拧上安全罩，检查作业地点，确认无着火危险方可离开。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent moral education curriculum system and management system, the construction of school. The soc