进玉电极（Into the jade electrode）.doc

进玉电极（Into the jade electrode） A brief description of the operation This electrode module is based on the layer and the copper name to manage the copper. Each and put a layer of copper, copper and each can naming it a name, the name in the copper and play a different role in the process of operation, such as in the process of looking for copper and, in the process of cutting the number of discharge process, the post-processing has a different role in the process. A brief explanation of the necessary introductions of this electrode module is given below. Finish general process: open a mould kernel all the copper in the male - use to multiple copper male named function to copper male name - the number of discharge (or last) - with multiple copper and formed a function of copper and the direction of the pendulum - use after straighten copper public material - use export a single copper public into a new format export copper and -- write copper and knife road and the post-processing program list. (this process is for reference only) 1. Copper removal: Circular command: a set of commands that Cancel (Cancel) press the button or Ese to enter the next command, Back button to exit the function. If there is no back button in the selection state, click the Classselection icon selected and the back button will appear. The order and addition of commands are changed in D: \ ju_conf \ config.def files. (it will save a lot of time if the relatively simple copper duke tries to use this feature.) Curved box: this command runs fast, but the disadvantage is that the calculation results are not very accurate. Automatic pruning with selected faces means automatic trimming of the box using the plane you chose to make box (just flat). Entity box: the advantage and disadvantage is the opposite of curved box. To trim an entity in a flat surface: choose a surface of the entity (which must be a flat) to be trimmed by this entity, and the direction of the pruning will always be in the out