CommandDictionary--LSLIMIT命令模式参数说明-GHSport.PDF

Command Dictionary ‐‐ LSLIMIT  命令模式 LSLIMit SHR | MMT | TOR = v1 [@ l1, ..., vn @ ln] Establishes the maximum allowable shear, bending moment, or torque values as a function of the longitudinal position on the vessel. 设定船舶纵向方向上不同位置的切力，弯矩或扭矩的许用值。 LSLIMit OFF Turns the limits off. 关闭许用值限制 LSLIMit TItle title Changes the title of the current longitudinal strength criterion. 改变当前总纵强度标准标题。 LSLIMit Display the current limits for shear, bending moments, and torque. 显示当前切力，弯矩和扭矩的许用值。 参数说明 SHR Specifies that the vi values given are for shear. 指定数值vi 为切力。 MMT Specifies that the vi values given are for bending moments. 指定数值vi 为弯矩。 TOR Specifies that the vi values given are for torque. 指定数值vi 为扭矩。 vi The maximum allowable shear (in current weight units) or bending moment (in current weight times length units) or torque (in current weight times length units) depending on whether SHR, MMT or TOR is specified. For SHR and MMT, two limits (one positive, the other negative) may be given and separated by the ampersand () character. For MMT, the same sign may be used for both maximum and minimum bending limits (but only where the actual bending moments cannot switch sign), in which case the minimum limits have no effect except to appear on the plot for comparison with the actual bending moment curve. vi 可以为切力许用值（当前重量单位）或弯矩许用值（当前重量单位乘长度单位）或扭矩许用值 （当前重量单位乘长度单位），取决于前面的指定SHR, MMT 或TOR 。对于切力和弯矩，可能 19 March 2014  (10‐LSLIMIT.1) Rev. G  Page: 1/  Command Dictionary ‐‐ LSLIMIT  给定两个许用值（正数和负数），用分隔。对于弯矩，最大和最小的许用值可能正负相同，此 时，可以只提供一组正数许用值，但对于实际的弯矩分布和正负值无任何影响。 Limits are ignored in the indicated direction by specifying INFINITY or -INFINITY at a location. 在某位置通过指定INFINITY 或 -INFINITY来忽略此位置的许用值的正负值(方向)。 li The longitudinal location at which the preceding vi value ap