文档详情

网众经典故障排错解析(The classic network fault Troubleshooting Analysis).doc

发布:2017-08-18约1.48万字共17页下载文档
文本预览下载声明
网众经典故障排错解析(The classic network fault Troubleshooting Analysis) 1. super households can not set Solution: in the file system editor: opt/netzone/nxp/superwks.ini superwks.ini, save the file inside the data emptied, and then the server service has a (ie: running in the command window: NXP restart) 2. households can not be canceled Solution: in the file system: all the setup files under opt/netzone/nxp/disk are deleted, and then reset the service. 3.. The workstation has a client that scrolls continuously in the XP scroll bar The solution: first, change the IP address of this client, usually IP address ChongTu. If there are too many or all of them, there may be more problems with the server. Please replace the server 4. server all normal, all work can not start, can not boot The solution: first, open the NXP manager to see if there is anything wrong with it. If nothing is normal, you can see the workstation record Check that the server network is connected properly, open the web site and see if the server network can open the site Restart the NXP service (i.e.: run in the command window: NXP, restart) 5., the server is very card, the workstation is also very card? Solution: first, check the server load (open the terminal: w---- to see if the first three digits are greater than 5, and if it is greater than 5, the server load is very heavy, and the lower 5 indicates that the server load is normal) Check whether the server is hard if there is an error (open terminal: dmesg |grep error, to see if there is a disk error information, open terminal: cat /opt/netzone/nxp/syslog.txt---- to see if there is no what special error), finally, look at the use of server and client. The replacement of a good server and the client. 6. server crash (server Caps Lock light and Scroll Lock light flashing) Solution: the most common server memory problem is the replacement of memory tests Secondly, check if the hard disk is normal, if there is no error. Replace the power test 7. turn on the N
显示全部
相似文档