NXPISP1506ULPI收发器解决方案.docx

PAGE 1 PAGE 1 NXPISP1506ULPI收发器解决方案 NXP公司的ISP1506是4位双向ULPI收发器,能为ASIC和FPGA器件供应高速USB模拟前端解决方案,从而实现高速USB主机接口,外设接口和OTG接口. ISP1506评估板为设计者供应了评估ISP1506的特性,以及进行系统级的确认和测试.本文介绍了ISP1504评估板的主要性能,连接器和具体的应用电路图. The ISP1506 is a 4-bit bidirectional UTMI+ Low Pin Interface (ULPI) transceiver, which provides a Hi-Speed Universal Serial Bus (USB) analog front-end solution to Application-Specific Integrated Circuits (ASICs) and Field Programmable Gate Arrays (FPGAs) to implement as a Hi-Speed USB host, peripheral or OTG device.  The ISP1506 evaluation (eval) board allows you to evaluate the features of the ISP1506 for performance measurement and functionality characterization. The eval board also allows the ULPI Transceiver and Macrocell Tester (Toptional external 1.5 kΩ low-speed pull-up resistor on DM provided on-board On-chip 45 Ω resistors on DP and DM for high-speed terminationAll UTMI+ static signals are accessed using register map60 MHz clock out (4-bit DDR data interface that clocks on both the rising and falling edges of the clock), can be configured to drive 60 MHz from the USB link on the same pinSupports full-speed and low-speed UTMI+ serial interfaceSupports high-speed, full-speed and low-speed disconnect detection4-bit DDR data bus that allows USB packet transaction and register accessSupports UTMI+ OTG interface with an internal 50 mA charge pump, or an external VBUS switch or charge pump; an external solution must be used for VBUS current requirements higher than 50 mA. 2.2 连接器 USB connectors: standard-A, standard-B and mini-ABULPI through Tamp;MT connectorInput power connector. 2.3 电源 The board power can be directly supplied from an external power supply or from a link through the Tamp;MT connector.The VBUS power supply is generated from the on-chip charge pump or from the link through the Tamp;MT connector.  图1.ULPI Tamp;MT卡方框图  图2.ISP1406评估板电路图.  图3.ISP1406评估板电路图(2). 表1.ISP1406评估板元器件清单(BOM