RIPv2认证实验.docx

实验二:RIPv2认证实验附：ospf认证实验R1：RouterenRouter#conf tRouter(config)#ho R1R1(config)#int s0/3/0 //接口R1(config-if)#ip add 12.12.12.1 255.255.255.0 //配IPR1(config-if)#no sh //激活%LINK-5-CHANGED: Interface Serial0/3/0, changed state to down%LINK-5-CHANGED: Interface Serial0/3/0, changed state to up%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/3/0, changed state to upR1(config)#router ospf 1 //启用ospfR1(config-router)#router-id 1.1.1.1 //ID号R1(config-router)#int s0/3/0R1(config-if)#ip ospf authentication //启用认证R1(config-if)#ip ospf authentication-key cisco //密码CISCOR1(config-if)#end%SYS-5-CONFIG_I: Configured from console by consoleR2：RouterenRouter#conf tEnter configuration commands, one per line. End with CNTL/Z.Router(config)#ho R2R2(config)#int s0/3/0R2(config-if)#ip add 12.12.12.2 255.255.255.0R2(config-if)#no sh%LINK-5-CHANGED: Interface Serial0/3/0, changed state to up%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/3/0, changed state to up%Invalid interface type and numberR2(config)#int s0/3/1R2(config-if)#ip add 23.23.23.1 255.255.255.0R2(config-if)#no sh%LINK-5-CHANGED: Interface Serial0/3/1, changed state to downR2(config-if)#%LINK-5-CHANGED: Interface Serial0/3/1, changed state to up%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/3/1, changed state to upR2(config)#router ospf 1R2(config-router)#router-id 2.2.2.2R2(config-router)#int s0/3/0R2(config-if)#ip ospf authenticationR2(config-if)#ip ospf authentication-key ciscoR2(config-if)#end%SYS-5-CONFIG_I: Configured from console by consoleR2(config-router)#int s0/3/1R2(config-if)#ip ospf authentication-R2(config-if)#ip ospf authentication-key ciscoR2(config-if)#end%SYS-5-CONFIG_I: Configured from console by consoleR3：RouterenRouter#conf tEnter configuration commands, one per line. End with CNTL/Z.Router(config)#int s0/3/1Router(config-if)#ip add 23.23.23.2 255.255.255.0Router(config-if)#no sh%LINK-5-CHANGED: Interface Serial0/3/1, changed state to up%LINEPROTO-5-UPDOWN: Line protocol on Interf