OBD诊断连接线制作.pdf

ENET CABLE BUILD These are my instructions for putting together an Ethernet to OBD2 cable to change features on your F-Series vehicle using E-Sys, Toolset32, ISTA P/D or other BMW programming tool. You can build yours any way you like but this is how I do it. These are the tools I use to make my cables. The only specialty tool is the network cable crimper. Im using a simple and cheap multimeter to show that you dont need anything special to test your cable. The only thing missing from the picture is the OBD2 connector. First I test the resistor to make sure it doesnt fluctuate all over the place. So long as it sits stable between 506 and 560 ohms you are set. I use 510 ohm, 1/4 watt resistors, but other people have used 560 ohm, 1/4 watt resistors and been perfectly fine. Next put on the RJ-45 boot and OBD2