《Quickbuilder点参数modbus地址格式.》.pdf
文本预览下载声明
Defining a Modbus Address for a Point Parameter 给一个点参数规定一个Modbus 地址
Entering an Address 访问一个地址
For PV Source Address, Source Address, and Destination Address the format for an Modbus
controller address is: 一个Modbus 控制器地址的PV 源地址,源地址和目标地址格式 是:
ControllerName Location 控制器名字 位置
Part 部分
Description 描述
ControllerName 控制器名
The name of the Modbus controller. Modbus 控制器的名字
Location 位置
The address within the controller where the value is stored. See Location Syntax.
这个值储存在控制器里的位置。查看Location Syntax.
If you would like help when defining an address, click next to Address to display Address
Builder.
当你规定地址的时候如果你希望得到帮助的话,点击下一步去处理建立地址的显示
Using the Address Builder to Enter an Address 用这个地址建立提示去建立地址
To specify a Modbus controller address, specify the items as follows: 制定一个Modbus 控制器
地址,制定项目如下:
Property 性能
Description 描述
Address Type 地址类型
Select Controller.选择控制器
Controller 控制器
Select the a ropriate Modbus controller. 选择一个适当的Modbus 控制器
Location 位置
The address within the controller where the value is stored. See Location Syntax.
这个值储存在控制器里的位置。查看Location Syntax.
Location Syntax 位置语法
The format for the location is:位置格式是:
Address [DataFormat|BitNumber] 地址[数据格式|字节数]
Part 部分
Description 描述
Address 地址
The address (decimal) for the parameter value within the controller table.
在控制器表格里参数值的地址
If the address is prefixed with the table number, omit the table number. For example, the first
register in table 4 is often written as 40001 or 400001. Enter 1 as the address.
如果位址与表数目一起前缀,省略表数目。例如,在表4里的第一个注册位置经常
被写成40001或者400001.写1作为地址。
The table number prefix is shown on the Scanning tab of the Point Detail display and when you
use the commands listag, rtusum and lisscn.
前缀的桌面数被显示在点细节显示扫描界面 当你用listag,
显示全部